Roofing,
Ceiling and Gutters
• 30 lb felt roofing felt
• 50 year Architect 80 roof shingles
• Standing Seam Metal
roofing in Galvanized steel and Aluminum
• White powder coated aluminum roof drip edge
and flashings
• Colored Aluminum gutters and downspouts
• 3/12 Pitch
Non Storage Rafter Roof System at 24"
on Center. Attic Access Panel Included.
(Optional 4/12,
8/12, and 12/12 Roof Pitch Available)
(Optional Storage,
Transverse, Hip, Gambrel or Complex Roof Systems
Available)
• 30 Year Architectural
Roof Shingles (Self Sealing)
(Optional Heavyweight
40 Year or 50 Year Architectural Shingles
Available)
• 5/8"
OSB Roof Sheathing with radiant barrier lamination
• Continuous
Eave and Ridge Vent
• R-19 Fiberglass
Batt or blown in place cellulose Insulation
with Vapor Barrier
• Front, Rear,
and Gable End Overhangs
• Fascia is
2x8 with one coat gripper primer and two coats
exterior grade semi gloss paint
• Vented White
Vinyl Soffits at rebuilt overhangs
• White Aluminum
Gutters and Leaders (Seamless)
• Roof trusses
are engineered specifically for each home.
• Roof loads
analyzed so that point loads are supported
down to solid foundation points.
• Truss framing
on 24" center.
• Hurricane
clips are fastened to every truss and wall
top plating.
• Roof sheathing
is Tech shield 5/8” with clips
• 30 lb. Asphalt
saturated felt underlayment.
• 18" to
36" starter strip depending on roof pitch.
• Aluminum drip
and rake edging.
• Flashing configured
to not allow water to run behind siding where
one story roofs meet side walls.
• Valley flashing
configured to not allow water to run under
shingles where roofs meet.
• All seamless
rain gutters on house and garage.
• Shingle-over
ridge vent per code
• 5/8"
type "X" gypsum board on ceilings
with textured finish
• Sprayed texture
ceilings (popcorn) optional |
